External I/O - Panasonic KX-HCM280A Operating Instructions Manual

Panasonic operating instruction network camera kx-hcm280a
Hide thumbs Also See for KX-HCM280A:
Table of Contents

Advertisement

3.3

External I/O

The external I/O terminal can be used to connect an external input device (such as
a door sensor or motion sensor) and an external output device (such as a light).
By connecting an external sensor to the External I/O, the camera can buffer/
transfer images by alarm when there is a sensor detection (page 91). If the alarm
position has been registered (page 26), you can set the camera to aim the lens to
the alarm position when the alarm is triggered.
An external output device can be controlled by pressing the Output Control buttons
on the operation bar. The signal type sent to the device from the camera to the
external device can be set by clicking [External Output] on the Setup page
(page 106).
Explanation of the External I/O
Pin
1
GND pin
2
DC Power Output Terminal
3
External Sensor Input
4
External Device Control Output
Note
The External I/O (Input/Output) are independent. Output terminal is controlled
only by External Output Control page on page 106.
[For assistance, please call: 1-800-272-7033]
10.5—13.5 V DC
Maximum of 100 mA load drive is possible.
Use it by opening or GND short-circuit.
You can control it on the External Output page (see page 106).
It is an open collector circuit, and the maximum drawing-in current
is the same as pin 4. Do not exceed the voltage of DC power
output terminal (pin 4).
Features
Operating Instructions
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents