Diag-Menu Operations - Panasonic AJ-LT85P Operating Instructions Manual

DIAG-MENU OPERATIONS

The unit's system software version display, hour meter displays for the drum motor, rotating heads, etc. (for number of hours
used can be viewed on the DIAG menu.
DIAG-MENU HOUR METER
<VTR-2>
＊
H00 OPERATION
H01 DRUM RUN
H02 TAPE RUN
H03 THREADING
H11 DRUM RUN r
H12 TAPE RUN r
H13 THREADING r
Hour meter display
To transfer from a regular mode to the DIAG mode:
! Set the unit to the jog mode.
• Remember that the mode cannot be transferred in the shuttle mode.
@ Press the DIAG (SHIFT+REC) buttons. (This cannot be done by remote control.)
The hour meter displays appear on the VTR1 and VTR2 monitor screens.
# Turn the dial to move to an item.
Turn it clockwise (FWD) to move down and counterclockwise (REV) to move up.
To display the version:
! Press the FF button on the VTR2 while holding down the SHIFT button.
The display changes from hour meter to version.
To return from the DIAG mode to the normal mode:
Press the DIAG (SHIFT+REC) buttons.
DIAG-MENU
<VTR-2>
10000H
DISPLAY
10000H AV-SYSCON
10000H SBC
10000T CYLINDER
10000H
REEL
10000H END
10000T
71
Ver<1.00-00>
Ver<1.00-00>
Ver<1.06-00>
Ver<1.00-00>
Ver<1.00-00>
Version display
(Above display is version for
VTR2.)