Table of Contents
Advertisement
Problem
All buttons and
Circuit problem caused by electrostatic charge, impact,
switches are
etc. while the camera was connected to another device.
disabled.
The camera's
USB communication is in progress.
monitor screen is
blank.
I can't transfer
1) The camera is not set securely on the USB cradle.
images over a USB
connection.
2) The USB cable is not connected securely.
3) The USB driver is not installed.
4) The camera is turned off.
Display language
1) Camera's display language, Home city, date style,
setting screen
date and time, and other settings have not been
appears when the
configured.
camera is turned on.
2) A problem with the camera's built-in memory
management area.
Possible Causes
Other
274
Action
Remove the battery from the camera, reinsert it, and then
try again.
After confirming that the computer is not accessing the
memory card, disconnect the USB cable.
1) Check the connection between the camera and USB
cradle.
2) Check all connections.
3) Install the USB driver (page 216).
4) Press the USB cradle's [USB] button.
1) Check the settings (pages 12, 193).
2) Perform the reset operation to initialize the camera's
setup (page 139). After that, configure each setting. If
the language selection screen does not re-appear
when you turn the camera on, it means that the
camera's built-in memory management area has been
restored. If the same message appears after you turn
power back on, contact your retailer or a CASIO
service center.
APPENDIX
Advertisement
Table of Contents
