The procedures you need to perform when using the camera
with your computer and when using the bundled software are
different for Windows and the Macintosh.
• Windows users should refer to "Using the Camera with a
Windows Computer" on page 212.
• Macintosh users should refer to "Using the Camera with a
Macintosh" on page 235.
IMPORTANT!
• This camera supports USB 2.0 Hi-Speed protocol. Though
it can be used with a computer that supports only USB 1.1
protocol, higher speed data transfer becomes possible
when USB 2.0 Hi-Speed is supported. Note that certain
computer models, connecting through a USB hub, and
other system conditions can slow down data transfer and
even cause operational problems.
Using the Camera with a Windows
Computer
Install the required software in accordance with what version of
Windows you are running and what you want to do.
Windows
Objective
Version
• Viewing
XP/2000/
images on
Me
a computer
• Storing
98SE/98
images on
a computer
Transfer of
images from
the camera
XP/2000/
and
Me/98SE/
management
98
of images on
the computer
Retouch,
XP/2000/
rotate, print
Me/98SE/
snapshots
98
USING THE CAMERA WITH A COMPUTER
212
Install this software:
page:
–
(USB driver not required.)
USB driver Type B
(USB driver. Be sure to
install this driver.)
Photo Loader 3.0
DirectX 9.0c (When DirectX
9.0 or higher is not installed
on the computer already.)
Photohands 1.0
See
–
216
224
227