Installation - Bosch DWB068G50I User Manual And Installation Instructiions

en Installation instructions
If this is not possible, an all-pole
▶
isolating switch must be integrated
into the permanent electrical in-
stallation according to the condi-
tions of overvoltage category III
and according to the installation
regulations.
The permanent electrical installa-
▶
tion must only be wired by a pro-
fessional electrician. We recom-
mend installing a residual-current
circuit breaker (RCCB) in the appli-
ance's power supply circuit.
Sharp-edged components inside the
appliance may damage the connect-
ing cable.
Do not kink or trap the connecting
▶
cable.
¡ The connection data can be found
on the rating plate. → Page 19
¡ The connecting cable is ap-
prox. 1.30 m long.
¡ This appliance complies with the
EC interference suppression regu-
lations.
¡ The appliance corresponds to pro-
tection class 1. You should there-
fore only use the appliance with a
protective earth connection.
Preparing the wall
Ensure that there are no electrical
1.
wires, gas pipes or water pipes in
the area where holes are to be
drilled.
26
¡ Do not connect the appliance to
the power supply during installa-
tion.
¡ Ensure that the protection against
contact is guaranteed during in-
stallation.
12.10 Installation
Checking the wall
Check whether the wall is vertical
1.
and has sufficient load-bearing ca-
pacity.
Drill the hole depth in accordance
2.
with the length of the screws.
The wall plugs must have a secure
grip.
The screws and wall plugs en-
3.
closed are only suitable for use
with solid brickwork.
Suitable fasteners must be used
for other structures, e.g. plaster-
board, aerated concrete, Poroton
blocks, masonry bricks.
The maximum weight of the appli-
4.
ance is 16 kg.
Mark a vertical centre line on the
2.
wall from the ceiling to the lower
edge of the appliance.