Table of Contents
Advertisement
en Before using for the first time
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Turn the programme selector to
1.
Drum Clean.
Close the door.
2.
Pull out the detergent drawer.
3.
Pour approx. 1 litre of tap water
4.
into compartment II.
24
Pour standard washing powder
5.
into compartment II.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press Start/Reload to start the pro-
7.
gramme.
a The display shows the remaining
programme duration.
a In each case, the TimeLight altern-
ately shows the remaining pro-
gramme duration and the current
programme status on the floor.
a After the programme has ended,
the display shows: "End".
a The TimeLight is projected onto
the floor at the end of the pro-
gramme.
Start the first wash cycle or set the
8.
programme selector to Off to
switch off the appliance.
→ "Basic operation", Page 33
Advertisement
Table of Contents
