Table of Contents
Advertisement
GX-CD5100W
(2) Focus-RF system check.
Check the TE waveform at pin 16 on IC1.
If the waveform shown in Figure 4 appears and soon after NO
DISC appears ?
"Initialization" is possible, but play is not possible ?
"Initialization" is not possible.
(3) Spin system check.
Press the OPEN/CLOSE switch without inserting a disc, and
then try starting the play operation.
1. The turntable rotates a little ?
(Waveform drawing Figure 5)
2. The turntable doesn't rotate.
No
No
No
The tracking servo is not activated.
Yes
Check the peripheral circuits at pins 15, 16 and 23 on IC1,
and FFC1.
A normal jump operation cannot be completed or the begin-
Yes
ning of the track cannot be found.
Check the around pin 23 on IC1.
Data cannot be read. Check the VCO-PLL (Pin26~30 on IC1)
system.
TE
FDO
Yes
The spin driver circuit is OK.
Check around pin 25 on IC1, pins 5 and 6 on CNP2.
FDO
SPDO
7 – 3
Figure 4
Figure 5
Advertisement
Table of Contents
