Test Mode - Sharp GX-CD5100W Service Manual

GX-CD5100W

[4] TEST MODE

Setting the test mode
During stand-by mode, press ON/STAND-BY button
while pressing down the TAPE 2 STOP button and TAPE 1 STOP
button then, press the CD STOP button to enter the test mode.
C D
OPEN/CLOSE operation is using manual.
<< >>,<< >>buttons make pick's slide possible.
<<PLAY>> key input.
Do TOC IL. Do normal play.
When these following key is input into PLAY key, track num-
ber can be appoint directly.
<<STOP>> key input.
explanation:
a) Focus off set = "FOF_XXXX"
b)Tracking off set = "TOF_XXXX"
c)Tracking balance = "TBAL_XX"
d)Tracking Gain = "TGAN_XX"
f) Focus Gain = "FGAN_XX"
g) RF level shift = "RFLS_XX"
VOL — Last memory
P.GEQ — FLAT
SIMBA MODE — OFF
To cancel : Power OFF
T E S T
A
to page 2-4
STOP
IL isn't done
IL isn't done
IL isn't done
<<MEMORY>>
key input.
Adjustment result automatically will
display as below for each 2 sec:
a) "FOF_XXXX"
b) "TOF_XXXX"
c) "TBAL_XX"
d) "TGAN_XX"
f) "FGAN_XX"
g) "RFLS_XX"
2 – 3