Cable Requirements; Power Wiring - Johnson Controls S300 Series Hardware Installation Manual

S300-DIN-S
W
IRING
This section describes how to wire the DIN-mounted devices. For cable requirements, refer
to the user documentation for the particular device.
I
MPORTANT
Do not connect the DC power cable to the DIN-mounted device until all
wiring is complete.

Cable Requirements

Use the DC power harness for power and ground wiring. This cable assembly
contains the +24 VDC connector.
Connects to the DIN-mounted device

Power Wiring

To construct the power wiring, use listed 18 AWG wires.
24-10239-359 Rev. C
This document contains confidential and proprietary information of Johnson Controls
© 2017 Johnson Controls
CK722 module mounted in
the S300-DIN-S
Figure 1: DC Power Harness
Hardware Installation
COM
+24 VDC
connector
Chassis
ground
7