High Wind Centre Lift Lock (Only With R2W & R2F) - B&D Roll-A-Door 2 Series Installation Instructions Manual

Roll-A-Door Series 2 installation instructions
®
2.6.3 high wind centre lift lock (only with R2W & R2F)
a) Undo screws to separate lock from faceplate.
b) Fit faceplate to outside of door. Fig 2.6.3. Fit hooks onto
curtain edge, then slide faceplate as far to the right as
possible. Use adhesive tape to hold in position.
c) Attach the lock body to the faceplate from the inside, using
the mounting screws and washers. Do not
over-tighten the screws.
d) Attach self adhesive lock bar retainers. For additional
strength drill 2 x 1/8 holes from inside using retainer as a
template and fit 2 x 1/8 pop rivets to each retainer from
the face of the door.
e) With the door in the closed position make the lock hole
position in the side guides.
f) Drill and file out a slot:
(i) NO PADLOCK - no longer than 32mm and no wider than
10mm as in Fig 2.6.4a. Ensure top of the slot remains in
line with top of locking bar.
(ii) WITH PADLOCK - create slot as per i) then, additional 2
holes no smaller than 20mm, positioned central to slot
for waist high lock as in Fig 2.6.4b
g) Using pliers make an "S" bend in the locking bar to fit
through the slot as in Fig 2.6.4c.
locking bar
Fig: 2.6.4c
a) Slide bars through guide slot, then back, onto lock arms.
Screw on securely using 4mm x 6mm screws supplied.
For bottom rails with shoot bolt locking refer to Fig 2.6.5.
a) For fitting optional padbolt type locking, refer to Fig 2.6.6.
wave washer
flat washer
outside locking bar
bottom rail
inside locking bar
Fig: 2.6.6
NOTE: Please contact your B&D representative for all other lock solutions
cut away view
of padlock in place
"S" bend
head stop
this end first
self adhesive
locking bar
14
32
9
Fig: 2.6.4a
Washer Ø8
bolt - M8 x 50
50
Fig: 2.6.5
13
hooks
faceplate
lock body
lock arm
Fig: 2.6.3
20
17
Ø20
2 holes - position central
to slot for waist high lock
part of guide shown
in phantom for clarity
Fig: 2.6.4b
spacer - special shaped
to suit aluminium guide profile
32
nut - Nyloc
M8
spacer
5.5
A
50
bottom edge of guide