Motorola M68HC08 Reference Manual page 121

6.4.3 Software Execution
6.4.3.1 Build
6.4.3.2 Execute from Evaluation Board
DRM028 — Rev 0
MOTOROLA
Freescale Semiconductor, Inc.
To build the BLDC sensorless with the back-EMF zero crossing
application, open the bldc_zerocross.mcp project file and execute the
Make command, as shown in
application and all needed Metrowerks libraries.
Figure 6-5. Execute Make Command
To execute the application from MMDS evaluation board
(KITMMDSMR32), choose the Project/Debug command in the Code
Warrior IDE. This will start real-time debugger, load firmware, and
application software to evaluation board MMDS.
The application should then be started from the real-time debugger IDE
by the Run/Start command. For more help with these commands, refer
to the CodeWarrior tutorial documentation located in the CodeWarrior
installation directory.
User Guide
For More Information On This Product,
Go to: www.freescale.com
Application Hardware and Software Configuration
Figure 6-5. This will build and link the
Designer Reference Manual
User Guide
121