Osd; Resetting Lamp Timer; Main Osd Menu - Mitsubishi LVP-XD10U Operating Manual

Resetting Lamp Timer

If replacing the lamp before reaching 1000 hours of operation, carry out the following
procedure.
If replacing the lamp after 1000 hours of operations, carry out the following procedure.

OSD

Main OSD Menu

This Menu is not displayed when the signal is not
input.
Press the "Menu" key and the main OSD menu
structure will display as shown on the right (Fig.
19). Whenever AV box is attached, 4 sub-pages
will display in the menu: Display page, Image
page, Control page, and Source page. However,
if the input is from a PC and no AV box is
attached, Source page will not display in the
menu.
Press the "Menu" key again to enter Display page items, or press " " (KEYSTONE-) or " "
(KEYSTONE+) to select the sub-pages. (The main OSD menu will automatically disappear
if no key is pressed within 10 seconds).
OSD
0
OSD
Press the Standby/On button for 2 seconds to turn on
the lamp.
Press the MENU button to display the OSD menu,
and use the " " (KEYSTONE+) or " " (KEYSTONE-
) buton to select the Control page. Then press the
中
Menu button again to highlight the Lamp item.
The MENU is not displayed when the signal
is not input.
Press the " " (KEYSTONE+) or " " (KEYSTONE-)
button and the lamp usage time will display on the
bottom of the screen.
Within 3 seconds, press the MENU button to reset the
usage time.
Press the Standby/On button for 2 seconds to turen
on the lamp.
Within 15 seconds after "AFTER 2 MINUTES,
SYSTEM WILL POWER OFF" is displayed, press the
MENU button twice consecutiely.
Press the Standby/On button for 2 seconds to turn off
the lamp.
FUNCTION
FUNCTION
Figure 19 Main OSD menu
15
English