Table of Contents
Advertisement
Viewing computer images
A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the RGB cables that are connected to the
monitor.
to DVI
1
2
DVI
Pb
Cr/Pr
VIDEO
b/Pb)
R(Cr/Pr)
H/HV
V
Mini D-SUB 15pin-DVI
conversion cable
S-VIDEO
RS-232C
to DVI
1
2
DVI
b
Cr/Pr
VIDEO
DVI cable
Pb)
R(Cr/Pr)
H/HV
V
S-VIDEO
RS-232C
to BNC
1
DVI-I
DVI
Y
Cb/Pb
Cr/Pr
VIDEO
G(Y)
B(Cb/Pb)
R(Cr/Pr)
H/HV
V
Mini D-SUB 15pin-
DVI conversion cable
S-VIDEO
RS-232C
• Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending on
the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected images.
• When viewing images supplied from an BNC-connected computer, press the BNC button on the remote control.
• Also read the instruction manual of the equipment to be connected.
• Though the projected image may be displaced or displayed incorrectly when a VGA60 signal is output at the
startup of the computer, such symptom is not a malfunction. (This is because VGA60 signal is not supported.)
• This projector does not have any built-in speaker. To reproduce audio, use the speaker of the computer or connect
the projector to audio equipment.
• Images may not be projected correctly, depending on the type of the connected computer.
• Contact your dealer for details of connection.
B.
Plugging the power cord
Plug the power cord in the same way as in the case of "Connecting the projector to video equipment." See Page
15.
to monitor
port
to DVI
2
to monitor
port
For analog connection:
1. Connect one end of the supplied Mini D-SUB 15pin-DVI
conversion cable to the DVI terminal of the projector.
2. Connect the other end of the Mini D-SUB 15pin-DVI
conversion cable to the monitor port of the computer.
• Additional devices, such as a conversion connector and
an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable other than the supplied cable may
decrease the quality of projected images.
• When viewing images supplied from an analog-connected
computer, press the DVI-A button on the remote control.
• This projector does not support 3-line signals (SYNC-
ON-GREEN signals).
For digital connection:
1. Connect one end of a commercially available DVI cable to
the DVI terminal of the projector.
2. Connect the other end of the DVI cable to the DVI
terminal of the computer.
• Additional devices, such as a conversion connector and
an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected
images.
• When viewing images supplied from a digital-connected
computer, press the DVI-D button on the remote control.
• Turn on the power of the projector before that of the
computer.
For connection using the BNC terminal:
1. Connect one end of a commercially available Mini D-SUB
15pin-BNC conversion cable to five BNC terminals of the
projector.
2. Connect the other end of the Mini D-SUB 15pin-BNC
conversion cable to the monitor port of the computer.
EN-19
Advertisement
Table of Contents
