Installing The Camera With A Junction Box - Genie WIPX8VDVAF5 Quick Start Manual

Quick Start Guide
6. Insert a micro SD card. After that, adjust Zoom or Focus to obtain an optimum image.
7.

3.2 Installing the Camera with a Junction Box

1.
2. Rotate the trim ring anticlockwise to remove it from the camera and then loosen the
3. Route and connect these cables (take side conduit cabling for example). Then fasten
5. Install the lower dome back to the camera and fix it with screws. Then put the trim ring
10
8MP H.265 IP IR Vandal Dome with 3.3-12mm Auto Focus Lens and Facial Recognition
Before adjustment, view the image of the camera on a monitor. For Type A, press the T
or W button. For Type B, (a) push the IR light hood to the position, (b) remove the lens
cover, (c) adjust the Zoom and Focus, (d) install back the lens cover and move the IR
light hood back.
Insert a Micro
SD card
Type A : Motorised Zoom Camera
Install the lower dome back to the camera and fix it with screws. Then put the trim ring
onto the lower dome and then rotate it clockwise until it is locked. Finally, remove the
protection film softly.
Fix the junction box to the wall with screws.
screws to open the lower dome.
the camera to the junction box with screws.
onto the lower dome and then rotate it clockwise until it is locked. Finally, remove the
protection film softly.
Lens Cover
Monitor
Zoom-
Zoom+
Focus
Type B : Manual Zoom Camera
IR Light Hood
Zoom
4. Insert a micro SD card. Then
adjust the view of angle and the
image.