Pioneer PDP-508XG Service Manual page 34

1
" Confirmation of operations
Check that the HDMI Control function works properly.
A (1) Connect a device that supports the HDMI Control
function.
(2) Perform the procedures that are required after changing
connections, which are described in "Making the HDMI
Control connections" in the Operating instructions.
1 Turn on the plasma television and all the connected
devices.
2 Confirm that the setting in "Input Setting" for "HDMI
Control Setting" is properly entered according to the
connected devices. Also confirm the HDMI Control
related settings in the connected devices.
3 Switch to the HDMI input terminals to which the
B
devices are connected to check if audio and video
images are properly output and displayed.
4 Try turning off the plasma television, then turn the
power back on to the plasma television.
(3) Perform "Power On Test" or "Power Off Test" on the
HDMI Control Setting menu. (For details, refer to "Power
On/Off Test" in the Operating instructions.)
If the following occurs even if the operation check is
performed properly, a failure, such as breakage of the HDMI
cable, problems on the side of the connected device, and
C
problems with the MAIN Assy, may be suspected:
• "Power On Test" or "Power Off Test" cannot be selected
(the items are grayed)
• The connected device cannot be turned on/off.
In some cases, an operation check using another HDMI
input connector may be required in order to narrow down the
cause.
D
E
F
34
1
2
PDP-508XG
2
3
3
4
4