4. When you are prompted to select an interface, Nokia recommends that
5. After you complete the initial configuration, connect the network
Connecting Network Interfaces
Connect at least one network interface to the network to use as the Nokia
Network Voyager system-management interface.
You can also connect the remaining Ethernet interface cables at this point,
although you are not required to do so.
To connect 10/100 Ethernet devices, use a straight-through cable with an
RJ-45 connector to connect to a 10-Mbps or 100-Mbps hub.
For further details, see
You can use Nokia Network Voyager or the command-line interface (CLI) to
configure the remaining network ports on your IP200 appliance. Details about
Nokia IP200 Series Security Platform Installation Guide
For more information about how to respond to the prompts during the
initial configuration process, see the release notes for the Nokia software
release you are running.
you select one of the Ethernet management ports, which are numbered
eth-s5p1 through eth-s5p4.
To select an interface, enter the number adjacent to the physical ID in the
list of connected interfaces.
Note
A physical ID identifies the network interface card (NIC) type (eth)
and provides information about its slot number (slot-num) and port
number (port-num).
The physical ID syntax is:
eth-sslot-numpport-num
interfaces and use Network Voyager to configure them.
"Connecting to Ethernet Ports"
Connecting Network Interfaces
on page 52.
45