Renault ESPASE 2005 Manual page 28

FRONT SEATS WITH ELECTRIC CONTROL
Switches 1 and 3 recall the stored
seat positions: switch 1 is used to
adjust the seat base and switch 3 is
used to adjust the seatback.
For equipped vehicles, button 2 is
used for storing the chosen driving
position. It is possible to store a
driving position
RENAULT card.
The system operates:
- when the Hands-Free RENAULT
card is detected or, depending on
the vehicle, the remote control
RENAULT card
accessories position in the card
reader;
- on vehicles fitted with button 2;
this can also be used to open the
driver's door, with the ignition
switched off, for approximately
40 minutes.
For safety reasons, carry
out any adjustments when
the vehicle is stationary.
using the
is in the
Seat adjustments: switch 1
• To move forwards
Move it forwards.
• To move backwards
Move it backwards.
• To raise
Lift the rear of the switch.
• To lower
Lower the rear of the switch.
2
1
3
4
Seat adjustments: switch 3
To recline the seatback
Move the switch forward
backwards.
Adjusting the lumbar support of
the driver's seat
Move handle 4.
We would advise you not
to recline the seatbacks
too far back to ensure that
the effectiveness of the
seat belts is not reduced.
Make sure that the seatback is
locked in place correctly.
No objects should be placed on
the floor (in the area in front of
the driver) as these objects could
slide under the pedal during
braking manoeuvres,
obstructing its use.
or
thus
1.19