Deleting Print Jobs - AGFA Drystar AXYS XL User Manual

Deleting print jobs

During printing, you can always delete print jobs by entering the operator
menu.
To delete a print job, proceed as follows:
During a print job, the 'print' screen is displayed:
1. Press the Escape key to enter the operator menu.
The 'Operator menu' screen appears:
2. Press the Down key three times, followed by the Confirm key to select
'Delete jobs'.
A screen appears where you can choose between the option 'All jobs' or
one of the jobs in the print queue.
3. Do one of the following:
• If you want to delete all jobs at once, press the up/down arrow keys to
select 'All jobs', followed by the Confirm key. Proceed with the next
step.
• If you only want to delete a specific job in the print queue, press the
up/down arrow keys to select the desired print job, followed by the
Confirm key. Proceed with the next step.
4. A screen appears in which you need to confirm your delete request.
Press the Confirm key (YES) to confirm your choice, or the Escape key
(NO) to quit the procedure without any changes.
Drystar AXYS XL | Basic Operation (operator mode) | 79
Note: Only the print queue jobs with a status different from
printing (PR) or calculating (CA) will be shown.
3752B EN 20210601 1655