Stihl HTA 135 Instruction Manual page 13

8 Assembling the Pole Pruner
12
► Remove the protective cap (11).
► Turn the shaft (2) and press it in the direction
of the control handle (12) until the distance
c = 2 cm.
13
90°
c
► Align the housing (13) and transmission (3) as
shown.
► Tighten down the screws (9) firmly.
The pole pruner does not need to dismantled
again.
8.2 Attaching the clip
► Switch off the pole pruner and remove the bat‐
tery.
2
► Press clip (1) together and place on the han‐
dle hose (2).
It is not necessary to remove the clip again.
8.3 Mounting the machine support
► Switch off the pole pruner and remove the bat‐
tery.
0458-698-0121-B
11
2
c
3
90°
1
2
1
► Position the left half of the machine support (1)
against the side of the cover.
► Fit the screw (2).
► Position the right half of the machine sup‐
port (3) against the side of the cover.
► Fit the screw (5).
► Insert screws (4) and tighten.
► Tighten screw (2) and screw (5) firmly.
It is not necessary to remove the machine sup‐
port again.
8.4 Mounting and Removing the
Bar and Chain
8.4.1 Mounting the Guide Bar and Saw
Chain
The guide bar and saw chain combinations that
can be used with the chain sprocket are listed in
the specifications,
► Switch off the pole pruner and remove the bat‐
tery.
2
1
► Rotate the nut (1) counterclockwise until the
chain sprocket cover (2) can be removed.
► Remove the chain sprocket cover (2).
► Turn the tensioning screw (3) counterclock‐
wise until the tensioner slide (4) butts against
the left end of the housing.
English
5
3
21.1.
3
4
4
13