Kiwi-3P Matrix Features - Roland KIWI-3P Manual

Kiwi-3P Matrix Features

• 1024 Tones & 8 Sequences can be stored and edited, Sequences can be optionally linked to tones. It is also possible to
temporarily edit any Tone or Seq
Pulse Width Module is included with the Kiwi3P Matrix. This allows Pulse Width control and wave combinations.
•
• Saw, Pulse Width & Square Waveforms can be solo or mixed in any combination.
Sysex support for all and MidiCC for most parameters, Midi Sysex support for Tone Dump & Load
•
Patch Editor Control of Parameters (requires PE v 8.3 or later)
•
• Full Matrix system with 29 Source and 40 Destination types.
• Key Assign Modes are Poly Single, Poly Dual, Poly Triple, Unison & Solo
Each Key Assign mode can have Rotate/Reassign, Staccato/Legato, Steal/No Steal with five steal modes (Highest, Lowest,
•
Oldest, Newest, Quietest)
• Portamento in all key modes
• Note Detune available in all key modes, DCO 1 & 2 have separate Tune controls (±12 semitones) and DCO2 has a Fine Tune
(±50 cents). There is also an Analogue Feel parameter that adds a small random detune to notes.
Master Synth Fine Tune adjust in both hardware and software.
•
• Three independent envelope generators. These are traditional ADSR type and are modeled on the Original JX-3P . Each ENV
Mod can select from ENV 1 - 3 and has an Inverted or Normal modes. These are faster than the traditional JX-3P envelopes
Three independent Low Frequency Oscillators with 6 waveforms each. Each LFO Mod can select from LFO 1-3. LFOs can be
•
plus and minus base note or plus base note only.
• Midi Note Aftertouch (Channel & Note), Midi and Internal Modulation Level and Midi Note Dynamics are all Matrix sources
and can be sent any Matrix Destination.
LFO Button is a Matrix Source and can inject mod control to any matrix destination(s)
•
• Bend Lever is coded to DCO Frequency for Bend but is also a Matrix Source which can be sent to any Destination
• Front panel editing is available for all parameters. These can be edited via midi or the PG-200.
Master, Sequencer and Arpeggiator clocks can optionally display on the front panel
•
Key transpose allows transposition to any key. The range for this is -1 Octave to +2 Octaves
•
• Chorus has Manual Mode & variable speed
CHORD MODE
Any chord with up to 6 notes can be set and played from any key
•
ARPEGGIATOR
The Arpeggiator is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
•
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
Arp modes are Up, Down, Up and Down, Random, As Played, 1, 2, 3 or 4 octaves
•
Arp can be Started, Stopped & Continued using Midi Commands
•
• Appeggiator will Output Midi Data
SEQUENCER
8 separate 124 Max step Polyphonic sequences can be created and stored
•
• Sequences can be edited
• The Sequencer is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
• Sequencer can be Started, Stopped & Continued using Midi Commands
• Sequencer will Output Midi Data
PG-200
• Full PG-200 support
PG-200 will output midi data
•
www.kiwitechnics.com Kiwi-3P Matrix Upgrade User Manual v1.2
4