Sony SNC-CH135 Release Notes page 15

Release Note
21. Function changed and Problems corrected in Ver. 1.75
21.1. alarmdata.cgi sending problem when SSL is on
There was the problem that alarmdata.cgi could not be sent when SSL is enabled. This
problem has been solved.
(Problem from Ver. 1.31)
21.2. Incorrect return value by alarmdata.cgi during continuous motion detection
There was the problem that alarmdata.cgi has possibilities to return 0 (which indicates no
motion is detected) even though motion was detected continuously. The actual occurrence
frequency is rare. This problem has been solved.
(Problem from Ver. 1.50)
21.3. Throughput degradation in full-duplex transmission
When 10Mbps or 100Mbps full-duplex mode is specified by CGI command, Ethernet
throughput may be degraded. This problem has been solved.
(Problem from Ver. 1.05)
21.4. Improvement of responsiveness in multicast streaming
The CGI command responsiveness has been improved in multicast streaming.
(Problem from Ver. 1.05)
21.5. Error response to ONVIF command SetVideoEncoderConfiguration
There was the problem that the camera may return the "HTTP/1.1 500 Internal Server Error"
to ONVIF SetVideoEncoderConfiguration request.
This problem has been fixed.
(Problem from Ver. 1.05)
22. Newly Added Functions in Ver. 1.73.01
22.1. Supported Web Browser
Microsoft Internet Explorer Ver.9.0 is newly supported.
The verification test is executed for Windows 7.
22.2. Multicast address setting per video or audio instance
It is possible to set and request different multicast address respectively for image1, image2,
and audio.
For details, refer to the CGI Command Manual.
[Note]
This function cannot be used by ActiveX viewer, setting menu and the SNC toolbox.
22.3. Camera operating mode (SNC-CH240/CH280/DH240/DH240T/DH280)
Video capture used to always be done in 30fps. From this version it is possible to capture
video in 25fps besides 30fps by setting menu and CGI command.
For details on CGI command, refer to the CGI Command Manual.
15
Sony Corporation