Table of Contents
Advertisement
ENGINE OIL DIPSTICK
A
B
E134 0 4 0
A
MIN
B
MAX
ENGINE OIL CHECK
Note: Do not use oil additives or other
engine treatments. Under certain
conditions, they could damage the
engine.
Note: The oil consumption of new
engines reaches its normal level after
approximately 5000 kilometres (3000
miles).
Checking the oil level
Note: Make sure that the level is
between the MIN and the MAX marks.
Note: Check the level before starting
the engine.
Note: Make sure that your vehicle is on
level ground.
Note: Oil expands when it is hot.
The level may therefore extend a few
millimetres beyond the MAX mark.
Remove the dipstick and wipe it with a
clean, lint free cloth. Replace the dipstick
and remove it again to check the oil level.
If the level is at the MIN mark, top up
immediately.
Maintenance
Topping up
minutes for the engine to cool down.
Remove the filler cap.
Note: Do not top up further than the
MAX mark.
Note: Soak up any spillage with an
absorbent cloth immediately.
Top up with fluid that meets the
Ford specification. See Customer
assistance, warranty and service
guide
Replace the filler cap. Turn it until you feel
a strong resistance.
ENGINE COOLANT CHECK
Checking the coolant level
rinse the affected areas immediately with
plenty of water and contact your doctor.
Note: Make sure that the level is
between the MIN and the MAX marks.
Note: Coolant expands when it is hot.
The level may therefore extend beyond
the MAX mark.
If the level is at the MIN mark, top up
immediately.
-123-
WARNINGS
Only top up when the engine is
cold. If the engine is hot, wait 10
Do not remove the filler cap when
the engine is running.
(page
25).
WARNING
Do not allow the fluid to touch
your skin or eyes. If this happens,
Advertisement
Table of Contents
