Features And Terminology; Receiving; Unpacking; Contents Of Shipping Container - Jet JPJ-12B Operating Instructions And Parts Manual

5.0 Features and Terminology

6.0 Receiving

Carefully unpack the machine and any loose
items from the wood case and inspect for
damage. Any damage should be reported
immediately to your distributor and shipping
agent. Before proceeding further, read your
manual thoroughly to familiarize yourself with
proper assembly, maintenance, and safety
procedures.
Remove the clear plastic protective sheets and
remove the protective coating from the tables and
cutterhead. This coating may be removed with a
soft cloth moistened with kerosene. Do not use
acetone, gasoline, or lacquer thinner for this
purpose. Do not use solvents on plastic parts.
Use care when cleaning the
cutterhead; the knives are very sharp.

7.0 Unpacking

1. Remove all contents from the shipping
carton. Do not discard the carton or packing
material until the machine is set up and
running satisfactorily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
This machine arrives fully assembled. However,
some tools may be needed for adjustments.
Figure 1

9.1 Contents of Shipping Container

1 Planer/Jointer
2 Push blocks
1 6mm hex wrench
1 Aluminum knife gauge (JPJ-12B only)
2 Star point screwdrivers (JPJ-12BHH only)
10 Knife inserts (JPJ-12BHH only)
10 Knife insert screws (JPJ-12BHH only)
1 Owner's manual
1 Warranty card

8.0 Electrical Connection

must be done by a qualified electrician. All
adjustments or repairs must be done with the
machine disconnected
source, unplugged. Failure to comply may
result in serious injury!
The model JPJ-12B and JPJ-12BHH Planer-
Jointer is rated at 230V. This machine is not
supplied with a plug. Use a plug and outlet rated
at least 30 amps. The circuit for the machine
should also be protected by at least a 30-amp
circuit breaker or fuse.
Make sure the cutterhead rotates in the proper
direction. If it does not, disconnect machine from
power supply and reverse two of the phase wires
on the supply input.
7
All electrical connections
from the power