Starting / Stopping The Engine - Stihl HS 46 Instruction Manual

English
Filler cap is now closed.
If the filler cap will not engage into the
tank housing
The base of the filler cap is rotated in
relation to the upper part.
Look at the black alignment marks
N
on the top of the filler cap.
1
Left: Base of filler cap is rotated –
interior marking (1) is aligned
with the exterior marking.
Right: Base of filler cap is in the cor -
rect position – interior
marking is below the clip. It
does not align with the exte -
rior marking.
14
With the filler cap in the filling neck,
N
twist it counterclockwise until it
drops into its seat.
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position.
While pushing down on the cap,
N
twist the filler cap clockwise and
close it – see section "Closing."
Starting / Stopping the
Engine
Positions and Functions of Master
Control Lever
STOP
0
STOP or † – Master Control lever must
be pushed in direction of STOP or † to
switch off the ignition. When released,
the Master Control lever springs back to
the normal run position F and the ignition
is switched on again.
Normal run position F – engine runs or
can fire.
Starting throttle n – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position F when the throttle trigger is
squeezed.
HS 46, HS 46 C, HS 56 C