Table of Contents
Advertisement
English
Make sure you have a safe and
N
secure footing.
Hold the unit firmly with your left
N
hand on the fan housing and press
down.
Hold the starter grip with your right
N
hand.
Version without Easy2Start
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Version with Easy2Start
Pull the starter grip steadily.
N
As soon as the engine runs
Press down the throttle trigger
N
lockout and open the throttle – the
Master Control lever moves to the
16
run position F. After a cold start,
warm up the engine by opening the
throttle several times.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not rotate when the engine is idling.
Your machine is now ready for
operation.
Shut off the engine.
Move the Master Control lever in the
N
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
Other hints on starting
Engine stalls in cold start position l or
under acceleration
Move the Master Control lever to n
N
and continue cranking until the
engine runs.
Engine does not start in warm start
position n.
Move the Master Control lever to l
N
and continue cranking until the
engine runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Fuel tank run until completely dry
After refueling, press the fuel pump
N
bulb at least five times – even if the
bulb is filled with fuel.
Set the Master Control lever to suit
N
the engine temperature.
Start the engine.
N
HS 46, HS 46 C, HS 56 C
Advertisement
Table of Contents
