AEG L6TDR642G User Manual page 23

Table of Contents

Advertisement

3. Press the button Départ/Pause
again.
The programme continues.
11.11 Cancelling a running
programme
1. Press button Marche/Arrêt to cancel
the programme and to deactivate the
appliance.
2. Press button Marche/Arrêt again to
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
11.12 The ProSense System
load detection
After touching the Départ/Pause
button:
1. The ProSense System starts the
laundry load detection to calculate
the real programme duration. The
indicator
and the time dots flash.
2. After about 15 minutes the display
shows the new programme duration:
the indicator
dots stops flashing.
The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
The ProSense System
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
goes off and the time
The ProSense System is not
available with all
programmes such as :Laine/
Soie, Rinçage,
EssorageVidange, and
programmes with short
cycles.
11.13 Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the lid lock
indicator
you cannot open the lid.
To open the lid proceed as follows:
1. Press the button Marche/Arrêt
some seconds to deactivate the
appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Départ/Pause
The lid lock indicator
2. Open the appliance lid.
3. Close the lid and press button
Départ/Pause
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the lid
locked indicator
The indicator of Départ/Pause button
goes off.
ENGLISH
23
stays on and
for
.
goes off.
.
goes off.

Advertisement

Table of Contents
loading

Table of Contents