7-2: Scan Zone; Program P8: Edit-Insert Effect; 8-1: Routing; The Send Levels To The Master Effects - Korg Triton Studio Parameter Manual

1 Select "Copy Arpeggiator" to access the dialog box.
2 In "From" specify the source of the arpeggio settings
(mode, bank, number) that you wish to copy.
3 If you are copying from Combination, Song, or Song Play
mode, specify whether you wish to copy from A or B.
4 To execute the Copy Arpeggio operation, press the OK
button. To cancel, press the Cancel button.
7–2: Scan Zone
7–2a
7–2b
7–2a: Zone Map
This shows the Scan Zone setting.
7–2b: Scan Zone
Top Key
Bottom Key
These parameters specify the range of notes (keys) for which
the arpeggiator will function. "Top Key" is the upper limit,
and "Bottom Key" is the lower limit.
Top Velocity
Bottom Velocity
Specifies the range of velocities for which the arpeggiator
will function. "Top Velocity" is the upper limit, and "Bottom
Velocity" is the lower limit.
Note number and velocity can also be entered by hold-
ing down the [ENTER] key and playing a note on the
keyboard.
28
Program P8: Edit–Insert Effect
For details on insertion effects, refer to p.178 "8. Effect
Guide."
8–1: Routing
These settings specify the bus on which the output of the
oscillator will be sent, and can be used to adjust the send
levels to the master effects.
The following diagram shows the LCD screen when "Oscil-
lator Mode" (1–1a) is set to Double.
8–1a
7–1
8–1b
8–1c
8–1d
8–1a: Routing Map
This shows the status of the insert effects.
The insert effect routing, effect name, on/off status, and
chain is shown. The types of insert effect, on/off, and chain
settings are made in the P8: Edit-Insert Effect, Insert FX
page.
8–1b: Use DKit Setting
[C–1...G9]
Use DKit Setting
[C–1...G9]
This will be available only when "Oscillator Mode" (1–1a)
is set to Drums.
On (checked): The "BUS Select" (Global P5: 5–2a) setting for
each key of the selected drum kit will be used. Check this
[001...127] when you want to apply an insert effect to an individual
drum instrument, or to output an individual drum instru-
[001...127]
ment to one of the AUDIO OUTPUT (INDIVIDUAL) jacks.
If the "Oscillator Mode" is Single or Double, this setting has
no effect.
Off (unchecked): The setting of the BUS Select (8–1c), OSC
MFX Send (8–1d) parameter described below will be used.
All drum instruments will be sent to the specified bus.
8–1c: BUS Select (IFX/Indiv.Out Assign)
BUS Select (All OSCs to)
Specifies the bus to which oscillators 1 and 2 will be sent.
If this is set to 1/2 or 3/4, the oscillator pan settings (4–
1b, 4–4) will be used to output the sound in stereo from
AUDIO OUTPUT (INDIVIDUAL) 1/2 or 3/4. When
the oscillator pan is controlled by CC#10 (pan) or AMS
(Pan AMS), the sound will be output with the pan set-
ting that is in effect at note-on. Unlike the case when
this is set to L/R to output the sound from (MAIN) L/
MONO and R, the pan of a sounding note will not
change in realtime.
[L/R, IFX1...5, 1...4, 1/2, 3/4, Off]
8–1
[Off, On]