Phone Setup; Connecting The Phone - Grandstream Networks GXP1520 Quick Installation Manual

PHONE SETUP:

Installing the Phone (Phone Stand):
When installing the phone with the phone stand, attach the phone
stand to the bottom of the phone where there is a slot for the phone
stand (upper part, bottom part).
Installing the Phone (Wall Mount):
1. After attaching the phone stand, attach the phone to wall via the
wall mount holes.
2. Pull out the tab on from the handset cradle (See figure on the
right).
3. Rotate the tab and plug it back into the slot with the extension up
to hold the handset while the phone is mounted on the wall (See
figure the right).
3
Slots for the phone
stand if placing the
phone on a flat sur-
face
Wall mount holes
are available on
stand

CONNECTING THE PHONE:

Power
PC Port
LAN Port
To setup the GXP1520/1525, follow the steps below:
1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/
switch or a router (LAN side of the router) using the Ethernet cable.
3. Connect the 5V DC output plug to the power jack on the phone;
plug the power adapter into an electrical outlet.
4. The LCD will display provisioning or firmware upgrade information.
Before continuing, please wait for the date/time display to show up.
5. Using the phone embedded web server or keypad configuration
menu, you can further configure the phone using either a static IP
or DHCP.
Handset Rest
Tab with extension up
Tab with extension down
Handset Port
Headset Port
4