Husqvarna AUTOMOWER 305 Operator's Manual page 19

5.2 Cleaning
For better operation and longer service life, make sure
to clean the product regularly and replace worn parts.
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass. Clean the product
with a brush or running water from a water hose.
We recommend you to use a special cleaning and
maintenance kit. Speak to your local Husqvarna
representative for more information.
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents to clean the product.
5.3 Battery
WARNING:
using a charging station and power supply
which is intended for it. Incorrect use may
result in electric shock, overheating or
leakage of corrosive liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
WARNING:
recommended by the manufacturer. Product
safety cannot be guaranteed with other
batteries. Do not use non-rechargeable
batteries.
CAUTION:
The battery must be
charged before winter storage. If the battery
is not fully charged it can be damaged and
in certain cases be rendered useless.
The charging time can vary depending on, among other
factors, the ambient temperature.
Below indicates that the battery is getting old and
eventually needs replacing:
• The operating time for the product is shorter
than normal between charges. This leads to more
charging cycles than normal, which increases the
risk of tracks forming near the charging station.
• The product is frequently found standing out on the
Empty battery message. This indicates
lawn with
that the product does not have battery capacity
enough to find the charging station.
1508 - 010 - 17.01.2022
Only charge the product
Use only original batteries
The battery is fine as long as the product maintains a
well-cut lawn.
Note:
Battery life is dependent on the length of the
season and how many hours a day the product is
operating. A long season or many hours of use a day
means that the battery must be replaced more regularly.
Contact your local Husqvarna representative to replace
the battery.
5.4 Replace the blades
WARNING:
of the right type. Husqvarna can only
guarantee safety when using original blades.
Only replacing the blades and reusing the
screw can result in a screw wearing during
mowing. The blades can then be propelled
from under the body and cause serious
injury.
Replace worn or damaged parts for safety reasons.
Even if the blades are intact, they should be replaced
on a regular basis for the best mowing result and
low energy usage. All 3 blades and screws must be
replaced at the same time to obtain a balanced cutting
system. Use Husqvarna original blades embossed with
the crowned H-mark logotype, refer to
on page 26 .
5.4.1 To replace the blades
1. Switch off the product with the ON/OFF button.
2. Put the product upside down on a clean and soft
surface.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 screws.
5. Remove the 3 blades and the screw.
6. Attach 3 new blades and screws. Use Husqvarna
original blades.
7. Make sure that the blades can move freely.
Use blades and screws
Warranty terms
Maintenance - 19