Husqvarna AUTOMOWER 305 Operator's Manual page 14

a) Put the 2 ends of the boundary wire and the
end of the guide wire into the coupler.
Note:
Make sure that you can see the ends
of the wires through the transparent area of
the coupler.
b) Push down the cover on the coupler with
adjustable pliers to attach the wires in the
coupler.
10. Attach the guide wire to the ground with stakes or
bury the guide wire in the ground. Refer to
the wire into position with stakes on page 14 or
To bury the boundary wire or the guide wire on
page 14 .
11. Connect the charging station to the power outlet.
3.5.5 To put the wire into position with
stakes
CAUTION:
Make sure that the stakes
hold the boundary wire and the guide wire
against the ground.
CAUTION:
Cutting the grass too low
right after installation can damage the wire
insulation. Damage to the insulation may
not cause disruptions until several weeks or
months later.
1. Put the boundary wire and the guide wire on the
ground.
2. Put the stakes at a maximum of 75 cm / 30 in.
distance from each other.
3. Attach the stakes to the ground with a hammer or a
plastic mallet.
Note:
The wire is overgrown with grass and not visible
after a few weeks.
14 - Installation
3.5.6 To bury the boundary wire or the
guide wire
• Cut a groove in the ground with an edge cutter or a
straight shovel.
• Put the boundary wire or the guide wire 1-20 cm /
0.4-8 in. into the ground.
3.5.7 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
indicator of the charging station on page 20 and
To install the charging station on page 12 .
3.6 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
1. Put the product in the charging station.
2. Switch on the product.
To put 3. Push the arrow buttons and the OK button. Select
language, country, date, time and set a PIN code.
Note:
For some models, a factory PIN code is
necessary before you select a personal PIN code.
It is not possible to use 0000 as PIN code.
4. Push the Start button and close the hatch to initiate
a calibration process of the product.
Note:
Make a note of the PIN code. Refer to
Introduction on page 2 .
3.7 Menu structure
3.7.1 To get access to the menu in the
display of the product
1. Push the STOP button.
2. Use the number buttons and the OK button to
enter the PIN code.
3. Push the MENU button.
3.7.2 Submenus
There are a number of submenus under each option.
You can access all the functions to set the product
settings via the submenus.
Certain submenus contain options that are ticked off to
the left. This means that these options are selected.
Check or uncheck the box by pushing the OK button.
LED
1508 - 010 - 17.01.2022