Changing The Display Brightness; Setting The Clock; Turning Off The Power Automatically - JVC GVT0145-001B Instructions Manual

GAMMA Adjust if the neutral color is bright
or dark (–3 to +3).
BRIGHTNESS Adjust if the picture is bright or
dark as a whole (–8 to +8).
CONTRAST Adjust if the far and near positions
are unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct
(–8 to +8).
3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the screen, while holding down SHIFT, press VFP
again. The screen will automatically be erased after 9
seconds even if you do not press VFP.

Changing the Display Brightness

You can dim the display window.
DIMMER ON
DIMMER OFF
(Normal)

Setting the Clock

Main Unit
Without setting the built-in clock, you cannot use Daily/
Recording Timers (see page 34) and Sleep Timer (see next
column).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL/DEMO.
1
Activate clock setting mode.
CLOCK
/
TIMER
• If you have already adjusted the clock before, press the
button repeatedly until the clock time starts flashing.
16
Remote
ONLY
ONLY
2
Adjust the hour, then minute.
PRESET
Now the built-in clock starts working.
To check the current time when the System is turned on
2
sec.
SET
/ DISPLAY

Turning Off the Power Automatically

With Sleep Timer, you can fall asleep listening to music.
1
Specify the time (in minutes).
2
Wait until the set time goes off.
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can
change the shut-off time.
INFO
SET
/
DISPLAY
Clock
Source information
SLEEP 10 SLEEP 20 SLEEP 30 SLEEP 60
Canceled SLEEP 150 SLEEP 120
Remote
ONLY
SLEEP 90
SLEEP