Adjusting The Camera Angle; Attach The Dome Cover - JVC TK-C205VP Instructions Manual

Installation and connection

Adjusting the Camera Angle

Camera angle, zoom and focus are adjusted.
Horizontal
Lock screw
Variable
range 350˚
LENS
CENTER
FOCUS ADJ.
Switch
80˚
50˚
Vertical rotation
Rotation levers
Zoom ring
Focus ring
Tilt lock screws
E-14
Horizontal rotation
(adjustable range: 350°)
1.
Loosen the horizontal LOCK screw.
2.
Holding the both tilt lock screws, rotate
horizontally.
3.
Tighten the horizontal LOCK screw.
Vertical rotation
(adjustable range: +80°, -50°)
1.
Loosen the tilt lock screws.
2.
Holding the rotation levers, rotate
vertically.
3.
Tighten the tilt lock screws.
Image inclination
(adjustable range: ±15°)
Manipulate the rotation levers to adjust the
inclination of the image.
Adjusting the image size
Adjust the size using the zoom ring.
Adjusting the focus
Adjust using the focus ring.
1.
Adjust the Iris level adjustment prop-
erly
2.
Turn on the Focus ADJ. This will adjust
the proper exposure to be narrow depth
of focus by the electronics shutter of
CCD (AES) and that find out the opti-
mized focus point easier.
3.
Adjust the focus adjustment properly.
If an installation is made in the daylight,
use ND filter or a dark sunglass for a
fine adjustment.
4.
After focus adjustment, Turn off the
Focus ADJ.

Attach the Dome cover

The dome cover is mounted on the base.
Safety cable
1.
Remove dirt and soiling on the dome
cover. Otherwise, such dirt and soiling
may appear in the camera image.
2.
Set the dome cover to the unit by
aligning the 3 marks on the base and
dome cover (I, II and III).
3.
Securely tighten the special screws (3
locations) using the provided wrench.
4.
Remove the protective sheet affixed on
the dome cover.
CAUTION
• Be sure that dome cover is firmly at-
tached. Improper attachment could re-
sult in the cover dropping down.
• Be sure to not pinch the safety cable
between the dome cover and base. Wa-
ter proof and dustproof features may not
perform properly as aresult.
• Insert the safety cable of the dome cover
in the space between the base and cam-
era unit.
E-15