Power Supply - JVC 330 Service Manual

Safety
CRT yoke assemblies and other proximity electrical assemblies, components and
!
wiring—if performing the yoke rotation or width adjustment (outlined in Section
3.2), always use an
ANSI/ASTM 10,000 volt rated safety glove.
!
Periodically check the condition of safety gloves for cracks.
!
Arc Lamp main power ± posts.
!

Power Supply

The projectors operate from power sources indicated in the table below. Verify that local
power source matches these requirements before operation!
Projector Power Supplies
AC
Current
Hz
Watts
Handle the power cord carefully and avoid excessive bending.
A damaged cord may cause electric shock or fire. For continued safe and reliable
operation, only use cables supplied by the manufacturer for power and signal connections.
Installation should be performed by an electrician with current knowledge of electrical
codes in the country of use.
Fluid Safeguards
Certain components of the projector contain fluid. If any fluid from the projector contacts
the skin, wash off with soap and water. If any fluid from the projector splashes into the
eyes, rinse with cool running water.
Ventilation and Foreign Object Retrieval
Ensure the projector's multiple fans are free from obstructions and operating properly.
Air filters are located at vent ports on the cover. Air filters require periodic cleaning to
ensure adequate cooling of the projector (see Section 4.3). Verify that vent ports are clear
of all obstructions.
Keep the projector free from foreign objects, such as hairpins, nails, paper, etc. Do not
attempt to retrieve such objects yourself or insert metal objects such as wire and
screwdrivers inside the unit. If an object falls inside the projector, unplug the projector
immediately and call a Hughes-JVC certified technician for removal.
ix
Power 330
200-240V
20
50-60
2,700
340SC 370SC
200-240V 200-240V
20 30
50-60 50-60
3,325 4,550
Model 330, 340SC, and 370SC Service Manual