Table of Contents
Advertisement
Submenu
Warping
Zoom
Digital Zoom
POWER MANAGEMENT menu
Submenu
Auto Power On
Power Settings
This function aims at correcting the geometric distortion of the projector's
images when they are projected onto an uneven surface such as a cylinder, a
spherical shape, etc.
•
Enable
When this function is enabled, the following functions will not be available:
Keystone, Corner Adj..
•
Control Method
Allows you to select a preferred control method for warping adjustment.
•
Warping Adj.
This function is available when On is selected in the Warping > Enable menu
and OSD is selected in the Warping > Control Method menu.
1. Use
/ / /
2. Press OK to enter adjustment mode.
3. Use
/ / /
4. Press MENU to exit adjustment mode.
5. Repeat step 1 to 4 to adjust another point until you are satisfied with the
projected image.
6. Press MENU to exit the function.
•
Reset
Returns settings in the Warping menu to the factory preset values.
Zoom your lens between 0.8X ~ 2.0X. The default is 1.0 X.
Digitally zoom the vertical/horizontal focus from -50 to 50.
The function is not available when Zoom is 1.0X or higher.
•
Signal
When Signal is set to HDMI, projector will auto power up from standby mode
when HDMI signal is plugged into projector.
•
Direct Power On
Allows the projector to turn on automatically once the power is fed through the
power cord.
•
Auto Power Off
Prevents unnecessary projection when no signal is detected for a long time.
See
"Setting Auto Power Off"
•
Sleep Timer
Set the timer to turn off the projector. A confirmation message will pop up to
confirm turning off the projector when the timer counts down to zero.
•
Power Saving
Light source will enter low energy mode if there is no signal for 5 minutes.
Functions and Descriptions
to move the cursor to the point you wish to adjust.
to shift the point by x and y coordinates.
Functions and Descriptions
for details.
Menu Functions
29
Advertisement
Table of Contents
