Table of Contents
Advertisement
DIAGNOSTICS SYSTEM
The diagnostics system can be used to check the correct operation of all the components in the washing
machine.
After accessing the diagnostics routine, the display board is checked for correct operation. All the LEDs
(and, if featured, the display) light in sequence.
Press the FABRICS button to pass to the subsequent phase of the test (LED L1 lights).
Press the FABRICS button again to increment the number of the phase controlled. After the last phase, the
display returns to its normal condition. The LED corresponding to the phase being tested lights (L1 → L10).
Press the TEMPERATURE button to decrement the number of the phase controlled. After the last phase,
the display returns to its normal condition(L1 → L1).
PHASE
LED lit
0
All (in sequence) Tests the display board
1
L1
2
L2
3
L3
4
L4
5
L5
6
L6
7
L7
8
L8
9
L9
10
L10
TSE-P 04.00 EB
DIAGNOSTIC CONTROL SYSTEM
Water fill to wash compartment in the dispenser
Water fill to pre-wash compartment in the dispenser
Water fill to conditioner compartment in the dispenser
Hot water fill or cold water fill to bleach compartment (certain models only)
Heating (and, in Jetsystem models, circulation pump)
Rotation of drum at 250 rpm with water in the tub (test for leaks from tub)
Drain and spin at maximum speed; pressure switches.
Drying (washer/dryers only)
Displays the last alarm
Configuration of the main electronic board
34/50
Function tested
599 34 22-16
Advertisement
Table of Contents
