Electrolux NEAT Service Manual page 9

7. "START/PAUSE" button
START: After selecting the programme and the desired options, press the
START button to start the programme. The LED positioned above
the button will cease flashing and remain lit. If a delayed start time
has been selected, the countdown will commence; the countdown
will be shown on the display.
PAUSE: When the button is pressed again, the programme currently being
performed is interrupted. The LED above the button will start to
flash. When the cycle is paused, the door LED switches off and the
door can be opened on condition that:
- the machine is not performing a heating phase
- the water level is not high
- the drum is not in movement
When the appliance is paused, the programmes can be modified as follows:
→ The structure can be changed or the programme cancelled (SKIP/RESET button). In this case,
the water (and detergent) will not be drained and the new cycle will begin with water in the tub.
If it is preferred to restart the new cycle without saving water and detergent, it is necessary first
to select a drain phase and then the new programme.
→ The FABRICS and the TEMPERATURES can be modified only during the washing phase; in
this case, the cycle will be restarted from the beginning.
→ The SPIN can be modified before the start of the final spin cycle.
→ All the cycle OPTIONS can be modified before the commencement of the phase to be modified.
To re-start the programme, press the button again.
DRAIN and SPIN: after programmes with the RINSE HOLD option.
8. "SKIP/RESET" button
Thus button performs two functions:
Cancels the programme: Press the button until the cycle LEDs switch off. The display will show three
Selects special programmes: In the programme selection and execution phases, this button can be used
The cycle normally performed by the appliance consists of the following phases:
Wash - Rinses - Spins
Þ When the button is pressed once: Rinses - Spins.
Þ When the button is pressed twice: Spin
Þ When the button is pressed three times: Drain.
Þ When the button is pressed four times: Cancel programme.
If the PRE-WASH option is selected, it can be cancelled by pressing this button, so that the appliance
performs the wash only.
TSE-P 04.00 EB
flashing hyphens.
to cancel certain phases of the programme so that the appliance effectively
performs a special cycle. In the programme execution phase, the appliance must
be paused.
9/50 599 34 22-16