Table of Contents
Advertisement
1.8.2
ATX Power Connector (ATX_PWR1)
This connector is for an ATX Micro-Fit power supply. The plugs from the power supply are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
Important notes on the Motherboard Power Requirements
Make sure that your ATX 12V power supply can provide 8A on
the +12V lead and at least 1A on the +5-volt standby lead
(+5VSB). The minimum recommended wattage is 230W, or
300W for a fully configured system. The system can become
unstable and might experience difficulty powering up if the power
supply is inadequate.
You must install a PSU with a higher power rating if you intend to
install additional devices.
User's Manual
MX945GM2
35
Advertisement
Table of Contents
