Table of Contents
Advertisement
English
► If the mowing lines (2) cannot be pulled out to the required
length: Replace the spool (1) or the mowing lines (2).
The spool is empty.
13 After Finishing Work
13.1 After Finishing Work
► Shut off the engine.
► Allow trimmer to cool down.
► If the trimmer is wet: Allow the trimmer to dry.
► Clean the trimmer.
► Clean the air filter.
► Clean the deflector.
► Clean the cutting attachment.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
14 Transporting
14.1 Transporting the Trimmer
► Shut off the engine.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
► Carry the trimmer on your back.
► Hold the trimmer with your right hand on the control
handle.
► Hold the trimmer with your left hand on the loop handle.
► Transporting the trimmer in a vehicle: Secure the trimmer
to prevent turnover and movement.
24
15 Storing
15.1 Storing the Trimmer
► Shut off the engine.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
► Observe the following points when storing the trimmer:
– The trimmer is out of the reach of children.
– The trimmer is clean and dry.
If you store the trimmer for more than 3 months:
► Remove the cutting attachment.
► Open the fuel tank cap.
► Drain the fuel tank.
► Close the fuel tank.
► Have fuel tank cleaned by a STIHL servicing dealer.
► Start the engine and run it at idling speed until it stops.
16 Cleaning
16.1 Cleaning the Trimmer
► Shut off the engine.
► Allow trimmer to cool down.
► Clean the trimmer with a damp cloth or STIHL resin
solvent.
► Clean cooling air slots with a soft brush.
16.2 Cleaning the Deflector and Cutting Attachment
► Shut off the engine.
► Clean the deflector and cutting attachment with a damp
cloth or a soft brush.
13 After Finishing Work
0458-735-0121-A
Advertisement
Table of Contents
