English
4
5
6
7
8
1
9
► Place the thrust plate (8) on the shaft (1) so that its smaller
diameter faces up.
► Place the metal cutting attachment (7) on the thrust
plate (8).
► Place the thrust washer (6) on the metal cutting
attachment (7) so that its raised side faces up.
► Place the rider plate (5) on the thrust washer (6) so that its
closed side faces up.
► Insert the stop pin (9) in the bore as far as stop and hold
it depressed.
► Rotate the metal cutting attachment (7) clockwise until the
stop pin (9) engages in position.
The shaft (1) is now blocked.
► Fit the nut (4) counterclockwise and tighten it down firmly.
► Remove the stop pin (9).
7.5.2
Removing the Metal Cutting Attachment
► Shut off the engine.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the metal cutting attachment clockwise until the
stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove stop pin.
► Remove the rider plate, thrust washer, metal cutting
attachment and thrust plate.
18
8 Adjusting Trimmer for User
8.1
Fitting and Adjusting the Carrying System
► Put the carrying system on your back.
► Adjust straps until back padding is against your back.
8.2
Removing the Carrying System
► Shut off the engine.
► Loosen the straps.
► Take the trimmer off your back.
9 Mixing Fuel and Refueling the
Brushcutter
9.1
Mixing Fuel
A video is available for this chapter
www.stihl.com/sxpweh
This trimmer requires a fuel mixture of gasoline and two-
stroke engine oil., in a ratio of 50:1.
8 Adjusting Trimmer for User
0458-735-0121-A