Adjusting Nylon Line; After Finishing Work; When Work Is Finished - Stihl FSA 135 R Instruction Manual

13 After Finishing Work

Mowing with a mowing head (A)
► Swing the brushcutter steadily back and forth in an arc.
► Move forward slowly in a controlled manner.
Mowing with a grass cutting blade or brush knife (B)
► Mow with the left-hand side on the metal cutting
attachment.
► Move forward slowly in a controlled manner.

12.4 Adjusting Nylon Line

12.4.1 Line Feed on AutoCut Mowing Heads
► Briefly tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced. The line
limiting blade in the deflector automatically cuts the
mowing lines to the correct length.
2
1
0458-662-0121-A
A
Automatic feed will not take place if the mowing lines are
B
shorter than 25 mm.
► Switch off the brushcutter and remove the battery.
► Depress the spool (1) on the mowing head and hold it
depressed.
► Pull out the mowing lines (2) by hand.
► If the mowing lines (2) cannot be pulled out to the required
length: Replace the spool (1) or the mowing lines (2).
The spool is empty.
12.4.2 Line Feed on SuperCut Mowing Heads
Mowing lines are advanced automatically. The line limiting
blade in the deflector automatically cuts the mowing lines to
the correct length.
Automatic feed will not take place if the mowing lines are
shorter than 40 mm.
► Switch off the brushcutter and remove the battery.
► Pull out the mowing lines by hand.
► If the mowing lines cannot be pulled out to required length:
Replace the mowing lines.
The spool is empty.
13 After Finishing Work

13.1 When Work is Finished

► Switch off the brushcutter and remove the battery.
► If the brushcutter is wet: Allow the brushcutter to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the brushcutter.
► Clean the deflector.
► Clean the cutting attachment.
► Clean battery.
► If a metal cutting attachment is mounted: Fit the matching
transport guard.
English
23