0
0
0
9.
Press the Alternate key.
0
Non-Switched Configuration Verification
0
In a non-switched configuration two DUs are connected directly to
0
each other without going through the DMS-100 Family switch.
0
To verify the operation of a DU in a non-switched
0
ensure
that
0
standard DTE activity such as logging-on or transmitting data.
0
RACKMOUNT DU (NT4X25AD /CH /AV /DF)
0
Self-test
0
A DU self-test is performed automatically upon power-up,
0
be invoked manually by using the Self-test (Self Tst) push button
0
switch.
If a call is in progress when a self-test is performed,
0
the call will be dropped.
0
To Perform a Manual Self-test on the DU:
0
1.
Press the Self-test push button on the DU faceplate.
0
This causes the following to happen:
0
*
All LEDs on the face of the DU
0
four seconds.
0
If any of the LEDs flash, a failure is indicated.
0
*
All LEDs except for the Power LED turn off.
0
To
Perform
0
/DF)
0
1.
Unplug the DU from the shelf backplane, then plug the DU back
0
in to the backplane.
0
This causes the following to happen:
0
*
All LEDs on the face of the DU turn on for
0
four seconds.
0
If any of the LEDs flash, a failure is indicated.
0
*
All LEDs except for the Power LED turn off.
0
both
DTEs
and DUs are turned on, then perform any
A
Power-up
Self-test on the DU:
The Alternate LED turns off.
(NT4X25AD /CH /AV /DF)
light
297-2121-226
VINTAGE 05.01
configuration,
or
can
for
approximately
(NT4X25AD /CH /AV
approximately
5-9