Data Speed; Autobaud - Northern Telecom DMS-100 Series Installation And Maintenance Manual

0 297-2121-226
0 VINTAGE 05.01
0

Data Speed:

0 The Data Speed
0 speed of the data call.
0 Synch/Asynch/Autobaud:
0 This option is used to select the transmission mode, either
0 chronous, asynchronous, or autobaud where the data unit automat-
0 ically adjusts to the asynchronous speed of the terminal.
0 Local CTS Delay/CTS Delay A/CTS Delay B:
0 The CTS (clear to send) Delay
0 determines the length of the CTS (clear to send) delay.
0 When set to Local CTS Delay, the CTS delay is determined only by
0 the setting of CTS Delay A and CTS Delay B
0 Local CTS Delay option is not set, the CTS delay is determined by
0 CTS Delay A
0 (i.e., the time required for the CTS signal to
0 far-end unit), whichever is longer.
0 The CTS delay
0 and CTS Delay B options as shown in Figure 3.9 on page 3-21.
0 3-20
option is used to select the data transmission
option
and CTS Delay
timer is controlled by selecting the CTS Delay A
(NT4X25AF /AH)
selects the
options.
B or by the end-to-end delay time
return
syn-
method that
When The
from the