Manual Image Setup - IBM ThinkVision L190P User Manual

Manual Image Setup

If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
18
Normally, you can complete the setup procedure using
however, if your screen image is still distorted after you perform
or the Installation CD does not run on your system, perform
S
ETUP
.
I S
MAGE ETUP
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use an Arrow button (
and press the OSD Enter button
5. Using an Arrow button (
press again to access the Clock function
6. Use the Arrow buttons (
much as possible).
7. Next press the
8. Use the Arrow buttons (
liking. To save, press the
9. When finished, press the Exit button
You have completed the monitor manual image setup procedure.
at the bottom of the monitor to display
or ) to select the Image Setup icon
to access the function.
or ), select
or ) to manually adjust the image (as
button to select Phase.
or ), again to tune the image to your
button two times.
A I S
UTO MAGE
A
UTO
M
, press
MANUAL
see page
( 22) .
to exit from the OSD.
;
ETUP
I
MAGE
ANUAL
and then