Hunter SET & SAVE 44155C Installation And Operation Manual page 41

iConS anD fEaTurES, ConT.
3. Span setting mode – allows you to adjust
the system ON/OFF cycle rate. The default
setting is 2 (the system cycles ON or OFF
when the temperature is within 1
above and below the set temperature.) The
span setting can be adjusted if your system is
cycling too fast or too slowly.
Press and hold both the
until the word SPAN appears. Use the
button to adjust the span setting.
Down
(Up will increase your cycle time by allowing the system
to run longer; Down will decrease your cycle time by
causing the system to run for a shorter length of time.)
Span settings remain the same for
system settings. When batteries are
COOL
installed, or the unit is
will revert to 2.
o
and
Up Down
, the span cycle
RESET
41
F (0.5 o C)
buttons
or
Up
and
HEAT