Table of Contents
Advertisement
Service and Maintenance
Inspect entire V-belt for damage.
•
•
Replace damaged V-belts.
After installing new belts, run engine for 15
•
minutes, then check belt tension.
• To check the tension of the V-belt, use a tension
gauge (see 9.3).
- Place indicator arm 1 into gauge.
- Position gauge on V-belt 2, midway between
the pulleys, with flange 3 on bottom of gauge
against the edge of belt.
- Push slowly on the black pad 4 at right angles
to belt 2 until the spring is heard or felt to
trigger.
Page 46
25 890 2
- Carefully remove the gauge without altering
the position of the indicator arm 1.
Read off the value where the black indicator
arm 1 intersects scale 5 (arrow). For
settings, see 9.1
- If necessary, retension belt and measure
again.
Check tension and change belts only
!
with the engine off. Refit belt guard,
if provided.
Titan 701
6.4 Combustion Air Filter
6.5 Belt Drives
24 684 1
•
To replace, press in tension roller 1 using a
commercial tool and remove the V-belts.
Fit new V-belts.
•
The V-belt tension gauge can be obtained under
order number 8115 from:
COMPANY WILBAR
Postfach
14 0 5 80
D-42 826 Remscheid
When new V-belts are fitted, check the belt tension
after ca. 15 minutes running time.
24 684 1
IM 6004
Advertisement
Table of Contents
