Turni Ng The Saw On And Off; Transporti Ng The Saw - RIDGID R4550 Operator's Manual

TURNI NG THE SAW ON AND OFF

1.
The ON/ OFF paddle switch is located on the left side of the
front panel of the saw.
2.
Press the green ON button. Press the switch down to turn
the saw OFF .
When not in use, the saw should be turned off and the
3.
power swit ch locked out t o prevent unaut horized use.
To lock out power switch, use a standard long shackle
lock, with a shackle post no larger than 9/ 32 inch (7mm)
diameter.
See Figure 53.

TRANSPORTI NG THE SAW

To fold stand for moving:
1.
Return side extension tables to inner position lock side
extension into place.
2.
Stow Miter Gauge, Blade Guard, and Kickback Pawls.
3.
Lower riving knife to the non-through cut position. Then
lower the blade below the table.
4.
Grasping handle bar, push the stand release pedal
foot and tilt up and forward until the saw rests on the
wheels and stand feet.
See Figures 54 & 55.
OPERATI ON
with
A
31
ON ON
OFF OFF
LOCK LOCK
OUT OUT
Figure 53
A
Figure 54
Figure 55