Hunter 43044-01 Installation Manual page 3

6) Never place a switch where it can be reached from a tub or shower. Do not install this appliance in a tub or
shower enclosure.
7) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and standards.
8) When cutting or drilling into wall(s) or ceiling, do not damage electrical wiring or other hidden utilities.
9) Do not install this product in a wall. This product is designed for installation in ceilings up to a 12/12
pitch (45 degrees). Ductwork must point upward.
10) Ducted fans must always be vented to the outdoors. Keep ducting as short and as straight as possible.
11) Extreme caution is necessary when any is used by or near children or invalids and whenever the is
left operating and unattended.
12) To avoid motor bearing damage and noisy/unbalanced blower wheel, keep drywall spray, construction
dust, etc. off power unit.
13) Read specification label on product for further information and requirements.
14) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the unit.
15) Do not use this appliance with a dimmer switch or a fan speed controller.
16) To reduce the risk of fire or electrical shock, do not use this fan with any solid-state speed control device.
17) To prevent a possible fire, do not block air intakes or exhaust in any manner.
18) If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application
and be connected to a GFCI (Ground Fault Circuit Interrupter)-protected branch circuit.
3
43044-01 03/05/2008