Assembling And Hanging The Fan - Hunter 42775-01 Installation And Operation Manual

3-1. Unbundle the wires from the fan.
Note: Your Hunter fan comes with an optional downrod extension
pipe. If you are hanging the fan on a ceiling higher than 10 feet tall
and you would like to use the enclosed optional downrod, follow
Steps 3-9 3-13 on the next page.
–
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
For Standard or Angled mounting:
3-2. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-4. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim.
3 • Assembling and Hanging the Fan
6
42775-01 • 04/29/08 • Hunter Fan Company
Steps 3-2 – 3-3
U-shaped
Downrod
Canopy
Canopy
Trim Ring
Set Screw
Step 3-4
Hole