Extron electronics XTP R HWP 201 User Manual page 22

Remote power
The XTP R HWP 201 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
ATTENTION : XTP à distance est destiné à une utilisation en intérieur seulement.
Aucune partie du réseau qui utilise l'alimentation XTP à distance ne peut être routée en
extérieur.
Power injector
To power the XTP R HWP 201 remotely with an XTP Power Injector, power one device
locally (see Local power on page 14) and connect an XTP Power Injector to the XTP
cable run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
Tx Rx G Tx Rx Tx Rx G
RS-232 IR RS-232 POWER
12V
OVER XTP REMOTE
1.0 A MAX.
12V Local Power
Supply
XTP T UWP 202
Extron
XTP T UWP 202
XTP Transmitter
Figure 13. Typical Pont-to-point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power
to connected XTP devices (see the XTP matrix switcher user guide for more details). To
manage available power from the XTP matrix switcher, use the XTP System Configuration
Software with the XTP matrix switcher.
XTP OUT
Shielded Twisted
Pair Cable
100-240V 50/60 Hz
---A MAX
Power
XTP XTP PWR
PWR
Extron
XTP PI 100
XTP Power
Remote
Injector
Power
XTP R HWP 201 Wallplate Receiver • Installation
POWER
12V
--A MAX.
XTP R HWP 201
XTP IN
Extron
XTP R HWP 201
XTP Receiver
16