Section 1: Assembly & Set-Up; Tractor Requirements; Electrical Hook-Up - Land Pride AFM4214 Operator's Manual

Section 1: Assembly & Set-Up
Section 1: Assembly & Set-Up

Tractor Requirements

!
WARNING
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator's Manual to determine proper
weight requirements and maximum weight limitations.
Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used.
Horsepower Rating. . . . . . . . . . . 40-70 hp (30-52 kW)
Rear power take-off Shaft Type. . . . . . 1 3/8"-6 Spline
Rear power take-off Speed . . . . . . . . . . . . . . 540 rpm
Hitch Type. . . . . . . . . . . . . . . . . . . . . . . . . . . Drawbar
Hydraulic Outlets . . . . . . . . . . . . . . One duplex outlet
Electrical Hook-up (See Figure 1-1) . . . . . 7-Pin outlet
Tractor Weight . . . . . . . . . . . . . . . See warning above
Positive Hitch Weight on Tractor Drawbar
AFM4214. . . . . . . . Approximately 540 lbs (245 kg)
AFM4216. . . . . . . . Approximately 580 lbs. (263 kg)

Electrical Hook-up

Refer to Figure 1-1:
The LED wire harness is equipped with a 7-way round pin
connector for connecting to the tractor's 7-pin electrical
outlet shown in Figure 1-3.
11640
Tractor 7-Pin Electrical Outlet
Figure 1-1
16
AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M
Table of Contents
Drawbar Set-Up
Refer to Figure 1-2:
!
DANGER
To avoid serious injury or death:
Do not use a power take-off adapter. The adapter will increase
strain on the tractor's power take-off shaft causing possible
damage to shaft and driveline. It will also defeat the purpose
of the tractor's power take-off shield.
!
WARNING
To avoid serious injury or death:
•
Do not use a tractor that is too small or too large. Small
tractors can be pushed around and flipped over. Large
tractors can damage the attached implement.
•
Power take-off damage may occur if distances are not
properly maintained.
The 14" (36 cm) between center of drawbar hitch pin hole
to end of power take-off shaft and 8" (20 cm) from top of
drawbar hitch to center of power take-off shaft must be
maintained.
22273
14"
36 cm
Power Take-Off Shaft
Drawbar
Ground Level
Power Take-Off to Drawbar Distances
Figure 1-2
8" (20 cm)
18" to 21"
46 to 53 cm
11/19/21